Quality-Assured New 2 Machine Head Numerical Control Paper Tube
|Material||S304 stainless steel|
|Thickness of winding paper tube||2-8mm|
|Voltage||Current state preparation voltage|
Use attention points
1, Before using the equipment, check the situation, electrical
equipment, electrical switch is good, whether the line insulation,
screw, nut fastening, protective device is safe, and the refueling
point of lubricating oil, empty running 1 - 2 minutes before the
normal operation of equipment.
2, The equipment must be responsible for the use of other people.
Each part of the machine work, the work of non swing card, gauges
and other debris, the operating personnel are not allowed to leave
3, When cutting down, such as the use of ventilation machine
cutting paper, paper pipe cutting machine height can not exceed 125
millimeters, and according to the size requirements, with the
pressure iron fixation. Machine tool can only cut paper and not cut
other boards. Two or more operations should cooperate with each
other. When working, it is not allowed to extend the hand into the
press iron and blade to prevent cutting injury. If a special paper
cutting machine is used, it is not allowed to extend the hand into
the rotating core shaft to prevent the pressure injury.
4, Grinding, to prevent the paper involved in the trousers; adjust
the machine, note the hand grinding abrasive wheel.
This equipment can produce all kinds of parallel paper tubes, such
as printing and dyeing, cloth tube, tape, airflow spinning, food
packing tube and so on.
1. Wear the personal protective equipment properly. What should be
worn must be worn, and what should not be worn must not be worn.
For example, when the paper tube is machined, the female worker is
required to wear a protective cap. If not, the hair may be stranded
in. At the same time, gloves must not be worn. If worn, the
rotating part of the paper tube machine may wring the gloves in and
hurt the hands.
2. The paper tube machinery and equipment should also be inspected
according to the regulations. Especially
Paper tube machine
Paper tube machine (4)
It is to fasten the object to see if it is loose due to vibration
in order to re-fasten.
3, before the operation of paper tube mechanical equipment for
safety inspection, and empty car running, confirm normal, can be
put into operation.
4, equipment is strictly prohibited from running with faults, and
must not be used together to prevent accidents.
5. When paper machine is in operation, it is strictly prohibited to
adjust by hand, nor can parts be measured by hand or lubricated or
cleaned up. If necessary, mechanical equipment should first be shut
6. The tools, fixture and parts used for paper tube mechanical
equipment must be firmly fastened and not loose.
7, mechanical safety devices must be properly used according to
regulations, and must not be removed or used.
8. When the paper machine is running, the operator must not leave
the work place to prevent any problems from occurring.
9, after the end of the work, the switch should be closed, the
cutting tools and the work pieces are withdrawn from the working
position, and the work site is cleaned up, the parts, the jig and
so on are arranged in order, and the hygiene of the mechanical
equipment of the paper tube is cleaned.